3
Electrical
56
PA1
2020-05-12
S023074
Exterior Lights
For information on how to operate the lights refer to the operators manual. If it is necessary to
remove the lights for access during the conversion refer to the workshop manual for the correct
procedure.
NOTE
For additional information or technical support contact Aftersales@LEVC.com.
Additional External Lamps
All of the vehicles external lamps are LED. Do not connect additional electrical loads to the
lamps or lamp connectors.
Power for additional external lamps can be taken from the After Market In-line Connector,
page
67
.
The vehicle has locations for the installation of additional lamps on the roof. Refer to Roof,
page
38
for more information.
Reversing Lamps and Audible Warning Devices
The vehicle has an exterior sound module to warn pedestrians when it moves at low speeds.
Do not connect additional lights or audible warning devices directly to the reversing lamp. You
must connect to the wiring harness and install a relay to prevent additional electrical load on the
circuit.
Interior Lights
For information about the interior lights supplied with the vehicle refer to the operators manual.
If you install additional interior lights you can get power from the After Market In-line Connector,
page 67. The alternative is to install your own circuit, this must use an applicable fuse and
switch or relay
Cruise Control
WARNING
Do not make changes to the cruise control system. Modifications to the cruise
control system can cause the vehicle to malfunction.
For more information about cruise control or the speed limiter refer to the operators manual.
Lane Departure Warning
WARNING
Do not obstruct the sensors at the top of the windshield.
To Next Page
Loading...
