Body and Paint
2
S023074 PA1
2020-05-12
29
2. Remove the seven fasteners.
3. Release the access panel and disconnect the electrical connector from the accessory
socket.
Body Closures
General
Remove and install door seals carefully. Damage or incorrect installation can cause water
ingress or wind noise.
Do not modify the seal flanges or surfaces.
Security, Anti-Theft and Locking System
CAUTION
To avoid malfunction of the vehicles security systems contact LEVC before you
attempt to add additional security devices.
NOTE
For additional information or technical support contact Aftersales@LEVC.com.
Do not install additional locks in the areas shown. Holes drilled or mechanisms installed in these
areas will stop the operation of the factory installed locks. For more information refer to Drill
Zones,
page 20.
To Next Page
Loading...
