User Manual of Network Camera
98
1. Enter the Face Detection settings interface:
Configuration> Advanced Configuration> Smart Event> Face Detection
2. Check the checkbox of Enable Face Detection to enable the function.
3. (Optional) Check the checkbox of Enable Dynamic Analysis for Face
Detection, and then the detected face is marked with green rectangle on the live
video.
Note: To mark the detected face on the live video, go to Local Configuration>
Live View Parameters and enable the Rules.
4. Click-and-drag the slider to set the detection sensitivity.
Sensitivity: Range [1-5]. The higher the value is, the more easily the face can be
detected.
5. Click the Edit button to set the arming schedule.
6. Select the linkage methods for face detection, including Notify Surveillance
Center, Send Email, Upload to FTP, Trigger Channel and Trigger Alarm Output.
7. Click Save to save the settings.
To Next Page
Loading...
