Need help?Do you have a question about the LevelOne FCS-4041 and is the answer not in the manual?
Administrator sets host name, system time, password, network settings.
Administrator configures video resolution, rotation, compression.
Users program preset points, cruise paths, and camera parameters.
Configuration for host name, time zone, and synchronization settings.
Adding, editing, and managing user accounts and privileges.
Enabling secure HTTPS connections using certificates.
Restricting camera access by allowing or denying specific IP addresses.
Configuring IP address, subnet mask, gateway, and DNS settings.
Defining actions like PTZ movement or HTTP notifications upon alarm.
Adjusting parameters like sampling pixel interval, detection level, and sensitivity.
Specifying actions for motion events: outputs, messages, uploads, HTTP notifications.
Enabling and configuring the camera tampering detection and alarm.
Setting the video resolution and deinterlace mode for streaming.
Selecting MJPEG or H.264 compression and quality settings.
Setting the frames per second (fps) for MJPEG and H.264 streams.
Configuring audio transmission modes and bit rates.
Programming and recalling specific camera positions (presets).
Setting up automated camera movement paths (cruise paths).
Configuring automated panning movements for the camera.
Programming sequences of preset points for automated camera tours.
Adjusting exposure settings like shutter speed, iris, and gain.
Administrator sets host name, system time, password, network settings.
Administrator configures video resolution, rotation, compression.
Users program preset points, cruise paths, and camera parameters.
Configuration for host name, time zone, and synchronization settings.
Adding, editing, and managing user accounts and privileges.
Enabling secure HTTPS connections using certificates.
Restricting camera access by allowing or denying specific IP addresses.
Configuring IP address, subnet mask, gateway, and DNS settings.
Defining actions like PTZ movement or HTTP notifications upon alarm.
Adjusting parameters like sampling pixel interval, detection level, and sensitivity.
Specifying actions for motion events: outputs, messages, uploads, HTTP notifications.
Enabling and configuring the camera tampering detection and alarm.
Setting the video resolution and deinterlace mode for streaming.
Selecting MJPEG or H.264 compression and quality settings.
Setting the frames per second (fps) for MJPEG and H.264 streams.
Configuring audio transmission modes and bit rates.
Programming and recalling specific camera positions (presets).
Setting up automated camera movement paths (cruise paths).
Configuring automated panning movements for the camera.
Programming sequences of preset points for automated camera tours.
Adjusting exposure settings like shutter speed, iris, and gain.
General| Sensor Type | CMOS |
|---|---|
| Frame Rate | 30 fps |
| Lens Type | Fixed |
| Night Vision | Yes |
| Ethernet LAN | Yes |
| Day/Night | Yes |
| Camera Type | IP Camera |
| Network Interface | Ethernet |
| Supported Network Protocols | TCP/IP, DHCP, DNS, DDNS, RTP/RTCP, RTSP, SMTP, FTP, NTP, UPnP |
| Wireless Standards | IEEE 802.11b, IEEE 802.11g, IEEE 802.11n |
| Power Source Type | DC |
| Operating Temperature (T-T) | -10 - 50 °C |
| Operating Temperature | -10 - 50 °C |
| Operating Relative Humidity (H-H) | 10 - 90% |
| Operating Humidity | 10 - 90% |
| Video Output | No |
| Signal System | NTSC, PAL |
To Next Page