65
7.4.2 Cruise
The Cruise Programming can be found under this path: PTZ> Cruise.
The IP Camera supports up to eight Cruise Paths. Please follow the instructions
below for Cruise Path setup.
Cruise Setting
To setup a Cruise Path, please first select a path number from the drop-down
list. Then move the cursor to the live view pane, and move the camera to a
desired view (PTZ controls) as the start point of a Cruise Path. Click on the
<Set> button of <Record Start> and start programming the Cruise Path via PTZ
controls. When finishing programming, click on the <Set> button of <Record
End> to quit. Then this Cruise Path will be automatically recorded.
To Next Page
Loading...
