4.3 Macintosh Clients
From your Macintosh, you can access the Internet via the Wireless
Broadband Router. The procedure is as follows.
1. Open the TCP/IP Control Panel.
2. Select Ethernet from the Connect via pop-up menu.
3. Select Using DHCP Server from the Configure pop-up menu.
The DHCP Client ID field can be left blank.
4. Close the TCP/IP panel, saving your settings.
Note:
If using manually assigned IP addresses instead of DHCP, the
required changes are:
• Set the Router Address field to the Wireless Broadband Router's
IP Address.
• Ensure your DNS settings are correct.
47
To Next Page
Loading...
