Levoit LV-H133 Manual

11
Resetting the Air Purifier
It is necessary to reset the air purifier after changing the air filter.
There are two scenarios where you must reset the air purifier:
• Scenario 1: lights up red.
1. Replace the air filter (see Replacing the Air Filter,
page 10).
2. Press and hold for 3 seconds.
3.
purifier has been successfully reset.
• Scenario 2: The air filter was changed before
lights up.
1. Press and hold for 3 seconds.
2. The air purifier will chime to indicate that it has been
successfully reset.
Cleaning the Dust Sensor
Figure 5.1
The dust sensor uses an infrared light to detect airborne
particles. Accumulated dust, after a prolonged period of use, will
will continue to run on high speed while operating on Auto Mode,
and will not adjust itself to a lower speed setting.
1.
2. Open the dust sensor cover.
3. Use a cotton swab dipped in clean water to clean the
lens.
4. Dry the lens with a clean cotton swab. [Figure 5.1]
5. Close the dust sensor cover.
lens inside
opening
Purchasing a New Air Filter
To maintain your health and product performance, please only
use . You can purchase new
air filters from Amazon.com by searching for “B07DVWWC44”.
You can also scan the QR code below.
If you have any questions, please contact Customer Support
(page 14).

Levoit LV-H133 Specifications

General

Timer	Yes
Efficiency	99.97 %
Noise level	54 dB
Certification	CARB, FCC, ETL
Air purify rate	466 m³/h
Number of speeds	-
Noise level (low speed)	25 dB
Operating temperature (T-T)	-10 - 40 °C
Suitable for room area up to	41 m²
Operating relative humidity (H-H)	0 - 85 %
Particle filtration	0.3 µm
Filtering capability	Cigarette smoke, Fine dust, Pollen
Number of filter stages	3
AC input voltage	120 V
AC input frequency	60 Hz
Power consumption (max)	45 W
Power consumption (standby)	0.8 W
Control type	Touch
Display type	LED
Product color	Black

Weight and Dimensions

Width	318 mm
Height	600 mm
Weight	9500 g