7
About the Safety Trigger
Figure 2.1
When replacing the filter cover onto the air purifier, always make
sure the magnetic safety trigger is properly aligned with its
respective area. [Figure 2.1]
OPERATION
General Operation
1. Place the air purifier on a level surface. [Figure 3.1]
2. Plug the air purifier into a powered electrical outlet.
3. Tap to turn on the air purifier. It will start operating at
medium speed.
4. (Optional) Tap to adjust the fan speed of the air purifier.
There are 3 fan speeds to choose from (see Button Controls
& Functions, page 8).
5. Tap to turn o the air purifier when you are finished
using it.
NOTE: Always allow at least 15 inches (38 cm) of clearance on all sides
of the air purifier. [Figure 3.2]
Figure 3.1
Figure 3.2
NOTE: If the trigger is not properly aligned, the air
purifier will not turn on.
safety trigger makes
contact with the base
38 cm