Lexicon 300L - REV 1 - Page 51

Lexicon
300L Owner's Manual
3-22
-24 18 12 6 0 6 +12 ovld dB
L
R
-24 18 12 6 0 6 +12 ovld dB
L
R
-24 18 12 6 0 6 +12 ovld dB
L
R
If you are lost, and don’t remember which Bank and Program is currently running,
press MACH to restore the display of the currently running Bank and Program.
Remember, to load a Program after selecting a Bank, you must press PROG,
then enter a number. For example, to load WAVE AMB., in Bank 4 at program
location 0:
1. Press BANK
2. Press 4
3. Press PROG
4. Press 0
The display will read as follows (without flashing, as this is now the currently
running Effect.:
WAVE AMB.
300MA: B04P0
If you’ve modified an Effect and want to store it into an Effect Register, press
STOre. The display will show:
AVAILABLE
300MA: B1R1
The location for storing (B01R1 in this example) will be flashing. To select a
different register to store to, for example, Bank 5, Register 9, press BANK, then
press 5, then press REG repeatedly until the display shows:
AVAILABLE
300MA: B05R9
To store to the displayed location, press the STOre key again. The message
“STORED” will be displayed briefly before the display reverts to showing the
currently running effect.