Lexicon 300L - REV 1 - Page 54

3-25
System Operation
-24 18 12 6 0 6 +12 ovld dB
L
R
-24 18 12 6 0 6 +12 ovld dB
L
R
With both Effects loaded, you can now modify each Effect to suit your own needs.
Once you’ve done this, you should store each Effect into its own Effect Register.
To do this, you can follow the store procedure discribed earlier for the SINGLE
Effect — performing the procedure once for each Machine, OR you can store
both of effects as part of a Setup. To do this, press SETUP. The display will show:
DM: REV/DLY
DM: SET P102
Press PAGE, then press 6 to display the Setup naming page. Use the SELect
and CHG (change) sliders to enter the name “VOX/BRIX”.
Press the STOre key. The display will show:
AVAILABLE
DM: SET R 1
Press the STOre key again to save the Setup with the two modified Effects, and
automatically store each effect into its own Effect Registers. (Much easier!)