Lexicon
LXP-15 Owner's Manual
2-6
Loading a preset
If you have chosen a preset with "Pre scan" selected, press the button directly
below "Load" to load it. If you made your selection with "Preset" selected, you're
all set, since this mode automatically loads the preset you've selected. (For
footswitch control of preset changes, see Chapter 4:
Creating Sounds and
Effects
)
Once you've selected a preset, turn the PAGE knob to select one of the six
parameter pages (Delay, Pitch/EQ, Reverb, Level, Mod or Alg). One page of
parameters will appear on the display.
Preset 2 Bright Hall alg: Dly/Rvb
Decay Treble Bass Mpy Size Diffus
The PAGE knob will step through the other available parameter pages. You can
change the value of any parameter by selecting it (push the button directly
beneath it) and then turning the ADJUST knob to a new value.
When you turn the ADJUST knob, the bottom line of the display will change to
show the full name of the selected parameter and the selected value. These
values will change as you continue to turn ADJUST.
Preset 2 Bright Hall alg: Dly/Rvb
Decay Time 3.6s
Modifying a preset
Parameter value - this will
change as you turn ADJUST.
Full name of selected
parameter.
The screen will return to its normal 5-parameter display if you select another
parameter, or if 2 seconds pass without further parameter adjustment.
When the display returns to its normal state the setup name will be marked with
an asterisk to indicate that the setup has been modified. This asterisk will remain
until the setup is stored, or until another setup is loaded (clearing this setup and
any changes made to it).
The setup name is now
marked to show that it has
been modified
Preset 2 *Bright Hall alg: Dly/Rvb
Decay Treble Bass Mpy Size Diffus
Remember that pressing VIEW will display the parameters along with their
settings.
Decay Treble Bass Mpy Size Diffus
3.6s 8.98kHz 0.71x 64Meter 75%