Loading the multipurpose feeder
The multipurpose feeder can hold approximately:
• 100 sheets of 75‑g/m
2
(20‑lb) paper
• 10 envelopes
• 75 transparencies
Note: Do not add or remove paper or specialty media while the
printer prints from the multipurpose feeder or when the printer
control panel indicator light is blinking. Doing so may cause a jam.
LTR&LGL EXEC A5
A4
B5
1
4
5
6
2
3
1 Maximum paper fill indicator
2 Tray release latch
3 Paper release lever
4 Paper size indicators
5 Paper width guide
6 Width guide release tab
1 Press the tray release latch to the left, and then pull the
multipurpose feeder down.
2 Gently pull the extension out until it is fully extended.
3 Flex the sheets back and forth to loosen them. Do not fold or crease
the paper. Straighten the edges on a level surface.
Paper
* Avoid touching the printable side of transparencies. Be careful not to
scratch them.
Envelopes
Transparencies*
* Avoid touching the printable side of transparencies. Be careful not to
scratch them.
4 Load the paper or specialty media. Slide the stack into the
multipurpose feeder until it comes to a stop.
7
To Next Page
Loading...
