Paper jam in the fuser area
1 Open the front door.
Warning—Potential Damage: To avoid overexposing the photoconductor units, do not leave the front door
open for more than 10 minutes.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching it.
2 Open the printer top access cover.
3 Determine where the jammed paper is located, and then remove it:
a If the paper is visible under the fuser, then firmly grasp the paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
b If the paper is visible at the top paper guide in the fuser assembly, then firmly grasp the jammed paper on each
side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
c If paper is not visible, then remove the fuser unit:
Warning—Potential Damage: Do not touch the roller at the center of the fuser unit. Doing so may damage
the fuser.
1 Turn the screws on the fuser counterclockwise to loosen them.
Clearing jams 205
To Next Page
Loading...
