6 Load the paper stack with the recommended printable side faceup.
7 Place the paper guides securely against the edges of the paper.
8 Insert the tray.
9 From the printer control panel, set the paper size and paper type
in the Paper menu to match the paper loaded in the tray.
Note: Mixing paper sizes or paper types in a tray may cause
jams.
Loading the manual feeder
The standard 250‑sheet tray has an integrated manual feeder that can
be used to print on different types of paper one sheet at a time.
1 Load a sheet of paper into the manual feeder:
• Printable side facedown for one-sided printing
• Printable side faceup for two‑sided (duplex) printing
Note: There are different ways for loading letterhead depending
on the mode of printing.
One‑sided printing using a
letterhead
Two‑sided printing using a
letterhead
• Load envelope with the flap side up and against the right side
of the paper guide.
2 Feed paper into the manual feeder only to the point where its
leading edge can contact the paper guides.
Note: To achieve the best possible print quality, use only
high‑quality media designed for laser printers.
3 Adjust the paper guides to the width of the paper loaded.
Warning—Potential Damage: Do not force the paper into the
feeder. Forcing the paper may cause jams.
Loading the 650‑sheet duo tray
The 650‑sheet duo tray (Tray 2) consists of a 550‑sheet tray and an
integrated 100‑sheet multipurpose feeder. The tray is loaded in the
same way as the 250‑sheet tray and supports the same paper types
and sizes. The only differences are the look of the guide tabs and the
location of the paper size indicators.
CAUTION—POTENTIAL INJURY: To reduce the risk of
equipment instability, load each tray separately. Keep all other
trays closed until needed.
3
To Next Page
Loading...
