Changing the long-life photoconductor kit
71
Supplies information
Changing the long-life photoconductor kit
Warning: When replacing the long-life photoconductor kit, do not touch the blue drum. Touching the drum will
contaminate the long-life photoconductor kit and affect print quality.
1 Open the rear cover by sliding the release button to the right.
2 Remove the long-life photoconductor kit by pulling out on the extended tabs.
Warning: When rear door is open, be careful not to touch the attached roller. Touching the roller can cause
contamination and affect print quality.
To Next Page
Loading...
