Lexmark E120 - Host Interface Disabled

Overview of the Lexmark E120 operator panel
21
Using the operator panels
Host interface disabled
Jam in the printer paper path
Note: All jams show the same primary code. To determine
the jam location, view the secondary light sequence.
Light sequence:
Error—Blinking
Secondary light sequence:
Press twice quickly to see the secondary light
sequence.
Ready / Data—Blinks five times
Message:
Printer USB or network port disabled.
Solution:
• Press to clear message. Printer discards all jobs previously sent.
• Enable the USB port by selecting a value other than Disabled for the USB Buffer item in the Local Printer
Setup Utility (see Software and Documentation CD).
Light sequence:
Error—Blinking
Secondary light sequence:
Press twice quickly to see the secondary light sequence.
• Ready / Data—Blinks ten times
• Error—On
Message:
A jam has occurred at the input sensor, at the exit sensor, or between the input and exit sensors.
Solution:
See Clearing jams on page 53 for instructions.
Primary light
sequence
Secondary light
sequence
Primary light
sequence
Secondary light
sequence