Non-Lexmark imaging unit, see User’s Guide [33.xy]
‑ Blinking
‑ Blinking
‑ Blinking
‑ Blinking
If the printer control panel light sequence matches the light sequence in the preceding illustration, then the printer has
detected a non‑Lexmark supply or part installed in the printer.
Your Lexmark printer is designed to function best with genuine Lexmark supplies and parts. Use of third-party supplies
or parts may affect the performance, reliability, or life of the printer and its imaging components.
Warning—Potential Damage: Use of third-party supplies or parts can affect warranty coverage. Damage caused by
the use of third-party supplies or parts is not covered by the warranty.
All life indicators are designed to function with Lexmark supplies and parts, and may deliver unpredictable results if
third-party supplies or parts are used. Imaging component usage beyond the intended life may damage your Lexmark
printer or associated components.
To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your printer,
press
and simultaneously for at least four seconds to clear the light sequence.
Note: For the list of supported supplies, see the “Ordering supplies” section of the User's Guide or visit
http://support.lexmark.com.
Troubleshooting 119
To Next Page
Loading...
