Change [paper source] to [paper size] load [orientation]
‑ Blinking
‑ On
If the printer control panel light sequence matches the light sequence in the preceding illustration, then try one or
more of the following:
• Load the tray or feeder with the correct size and type of paper, and then press on the printer control panel to
continue printing.
• Make sure the correct paper size and type are specified in the Paper menu:
– If the printer is on a network, then access the Embedded Web Server.
1 Open a Web browser, and then type the printer IP address in the address field.
Notes:
• Print a network setup page or menu settings page, and then locate the IP address in the TCP/IP
section.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2 Click Settings > Paper Menu.
– If the printer is connected to a computer by a USB or parallel cable, then access the Paper menu through the
Local Printer Settings Utility for Windows or through Printer Settings for Macintosh.
• Press to cancel the print job.
Troubleshooting 125
To Next Page
Loading...
