• If the printer does not have a caster base, then remove the optional trays.
Note: Slide the latch on the right side of the printer toward the front of the printer until it clicks into place.
• Use the handholds located on both sides of the printer to lift it.
• Make sure your fingers are not under the printer when you set it down.
• Make sure there is adequate clearance around the printer.
• Use only the power cord provided with this product or the manufacturer's authorized replacement.
Warning—Potential Damage: Damage to the printer caused by improper moving is not covered by the printer
warranty.
Maintaining the printer 259
To Next Page
Loading...
