Lexmark MS810 - Some Held Jobs Were Not Restored; Supply Needed to Complete Job

SMTP server not set up. Contact system administrator.
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press
to confirm.
Note: If the message appears again, then contact your system support person.
Some held jobs were not restored
Select Continue to clear the message. For non‑touch‑screen printer models, press to confirm.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer models, press
to confirm.
• Turn off the printer and then turn it back on.
• Update the network firmware in the printer or print server. For more information, contact customer support.
Standard USB port disabled [56]
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press
to confirm.
Notes:
• The printer discards any data received through the USB port.
• Make sure the USB Buffer menu is not set to Disabled.
Supply needed to complete job
A supply needed to complete the job is missing. Cancel the current job.
Too many bins attached [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra bins.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Troubleshooting 300