For two‑sided, short‑edge printing
•
Load letterhead facedown with the header toward the left
side of the tray.
•
Load prepunched paper facedown with the holes against
the back of the tray.
Notes:
•
Do not slide paper into the tray.
•
Make sure that the side guides fit snugly against the
paper.
•
Make sure that the stack height is below the maximum
paper fill indicator. Overfilling may cause paper jams.
5
Insert the tray.
If necessary, set the paper size and type to match the paper
loaded in the tray.
Note: When a finisher is installed, the images are rotated to 180°
when printed.
Loading the 2520-sheet tandem tray
CAUTION—TIPPING HAZARD: To reduce the risk of
equipment instability, load each tray separately. Keep all
other trays closed until needed.
1
Pull out the tray.
Note: To avoid jams, do not pull out trays while the printer is
busy.
2
Adjust the guides to match the size of the paper that you are
loading.
3
Flex, fan, and align the paper edges before loading.
10
To Next Page
Loading...
