4
Load the paper.
•
For one-sided printing, load paper with the printable side
faceup.
•
For two-sided printing, load paper with printable side
facedown.
When loading letterhead or prepunched paper, do either of the
following:
For one‑sided printing
•
Load letterhead faceup with the header toward the back of
the tray.
•
Load prepunched paper faceup with the holes against the
left side of the tray.
For two‑sided printing
•
Load letterhead facedown with the header toward the back
of the tray.
•
Load hole-punched paper facedown with the holes against
the right side of the tray.
Notes:
•
Do not slide paper into the tray.
•
Make sure that the stack height is below the maximum
paper fill indicator. Overfilling may cause paper jams.
5
Insert the tray.
If necessary, set the paper size and type to match the paper
loaded in the tray.
Note: When a finisher is installed, the images are rotated to 180°
when printed.
Loading the 2000-sheet tray
CAUTION—TIPPING HAZARD: To reduce the risk of
equipment instability, load each tray separately. Keep all
other trays closed until needed.
1
Pull out the tray, and then open the tray side door.
Note: To avoid jams, do not pull out trays while the printer is
busy.
11
To Next Page
Loading...
