188
51
Removing an option card
If necessary, refer to the Setup Guide for instructions on accessing the printer system board.
WARNING: Electronic components are easily damaged by static electricity. Touch something
metal on the printer before you touch the card.
1 Locate the option you want to remove.
2 Loosen and remove the two screws over and under the slot. Gently pull the card out of the
connector on the system board.
3 Place the option card in its original packaging. If you did not save the packaging, wrap the card
in paper and store it in a box.
4 If you need to install another option on the system board, refer to the Setup Guide.
5 Refer to the Setup Guide for instructions on closing the printer system board cover.
To Next Page
Loading...
