9
Set up the printer and print media handling options
3 Plug one end of the jumper cord
into the printer. Plug the other end
of the jumper cord into the drawer.
4 Reconnect any disconnected
cables.
5 If you intend to operate your
2000-sheet drawer at 100–127V
power, instead of using the power
cord provided with the printer you
must use the 16 AWG power cord
provided with the 2000-sheet
drawer. Plug the 16 AWG power
cord into the back of the drawer
and then into a properly grounded
electrical outlet.
If you later decide to stop using the
2000-sheet drawer, you should
then use the original power cord
provided with the printer. The 16
AWG power cord should always
remain with the 2000-sheet
drawer.
If you intend to operate your
2000-sheet drawer at 200–240V
power, use the power cord
provided with the printer. Plug the
power cord into the back of the
drawer and then into a properly
grounded electrical outlet.
To Next Page
Loading...
