40
Load print media
Loading the 2000-sheet drawer Follow these instructions to load the
2000-sheet drawer. Do not load any print
media other than plain paper in the
2000-sheet drawer.
1 Open the loading door. If the
elevator tray is not already in the
lowered position, lower it by
pushing the elevator button.
2 Slightly bend the stack of paper as
shown and place it on the elevator
tray with the preferred print side
facing down. Align the stack of
paper to the back of the drawer.
Carefully align each stack of paper
as you load it to ensure a smooth
edge where the stacks meet. Do
not load paper above the load line.
This illustration shows the correct
orientation for loading paper for
simplex printing. Letterhead paper
should be loaded with the printed
side face down and the page top
against the front of the drawer. Do
not mix weights of paper.
For duplex printing on letterhead
paper, place the printed side face
up with the page top to the rear of
the drawer.
3 Close the loading door.
Elevator button
Load line
To Next Page
Loading...
