19
Set up the printer and print media handling options
Installing a finisher The finisher is shipped with a staple
cartridge already installed.
After you carefully unpack the finisher,
install it immediately; otherwise, the
edges of the mounting brackets could
damage tabletops or fabrics.
Warning: The finisher shelf is designed to hold the
weight of print media only. Excess weight may damage it.
1 Remove the top cover or any
previously installed print media
handling options.
Note: The finisher must be positioned directly above the
printer and below other print media handling options. It
cannot be used with a high-capacity output stacker. You
can only put either one 5-bin mailbox (T632 only) or one
output expander on top of the finisher.
To Next Page
Loading...
