36
Install memory and option cards
4 Align the connection points on the
card with the connector on the
system board and push the card
firmly into the system board
connector.
5 Insert the two screws saved from
the cover plate (or the extra screws
shipped with the card).
6 Tighten the screws to secure the
card.
Replacing the shield After you have installed option cards on
the printer system board, follow these
steps to reattach the shield and close the
doors.
1 Grasp the shield by the tabs and
align the three keyholes on the
shield with the top three screws.
Holding the shield by the tabs,
To Next Page
Loading...
