8
Set up the printer and print media handling options
Installing the 2000-sheet drawer Decide on an installation location for the
2000-sheet drawer. The printer, and
possibly other options, will be placed on
top of the drawer, so allow at least 137.16
cm (4.5 ft) for clearance.
Note: Your drawer is pre-configured to either letter or A4
paper size. To use a different paper size, see “Changing
the 2000-sheet drawer paper size” on page 10 before
placing any options or the printer on the 2000-sheet
drawer.
1 If you are installing the 2000-sheet
drawer sometime after setting up
the printer, turn the printer power
off and unplug the power cord.
Disconnect any other cables
attached to the printer.
2 Place the printer on top of the
drawer and any options installed.
The openings on top of the drawer
help you set the printer so the
edges are aligned properly. Make
sure the printer is securely in
place.
CAUTION: Make sure your fingers are not under the
printer when you set it down. Use the handholds on the
printer or ask someone to help you lift it.
To Next Page
Loading...
