Accessing the system board to install internal options
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,
and unplug any cables going into the printer.
Note: This task requires a #2 Phillips screwdriver.
1 Open the system board door.
2 Loosen the screw on the system board cover.
Additional printer setup
18
To Next Page
Loading...
Need help?
General
