Lexmark X203N - Network Reports Menu

Menu item Description
NPA Mode
Off
Auto
Sets the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol
Notes:
• Auto is the factory default setting.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Network Buffer
Auto
3K to <maximum size allowed>
Sets the size of the network input buffer
Notes:
• Auto is the factory default setting.
• The value can be changed in 1‑K increments.
• The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
• To increase the maximum size range for the Network Buffer, disable or
reduce the size of the USB buffer.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Mac Binary PS
On
Off
Auto
Sets the printer to process Macintosh binary PostScript print jobs
Notes:
• Auto is the factory default setting.
• The Off setting filters print jobs using the standard protocol.
• The On setting processes raw binary PostScript print jobs.
Std Network Setup
Reports
Network Card
TCP/IP
IPv6
Net <x> Setup
Reports
Network Card
TCP/IP
IPv6
For descriptions and settings of the network setup menus, see the following:
• “Network Reports menu” on page 107
• “Network Card menu” on page 108
• “TCP/IP menu” on page 108
• “IPv6 menu” on page 109
Network Reports menu
This menu is available from the Network/Ports menu:
Understanding printer menus
107