4-42 Service Manual
7526
7. Remove the toroid (G) from the UICC cable, and then remove the UICC, USB, speaker, and ground cables
from the cable clamps (H) above the system board frame.
8. Remove the cables through the frame, over the cartridge fan, through the cable clamps (I), and through the
frame holes (J) towards the front of the MFP.
9. Remove the fuser. See “Fuser assembly removal” on page 4-112.
10. Remove one screw (K) on the left side and two screws (L) on the right side, that secure the links.
To Next Page
Loading...
