4-72 Service Manual
7526
Installation notes:
a. When installing the bell crank link and spring back to the machine, guide the mounting hole on the
bell crank link to the mounting pin on the cartridge guide (E), and guide one end of the spring onto the
boss rest on the bell crank link and the other end onto the boss rest on the bell crank (F).
b. Make sure the locator pin on the bell crank rests on the locator hole of the bell crank link (G).
6. Use a prying tool to remove the bell crank.
Note: The bell crank must be replaced due to the damage that can occur to the retention features of this
bellcrank.
7. Perform steps 5 and 6 to the other bell crank links and bellcranks, except for the one found at the lower-
most portion of the cartridge guide.
To Next Page
Loading...
