58
1-2. Child safety
*1
: Move the front seat fully rearward. If the
passenger seat height can be adjusted,
move it to the upper most position.
*2
: Adjust the seatback angle to the most
upright position. When installing a for-
ward-facing child seat, if there is a gap
between the child seat and the seat-
back, adjust the seatback angle until
good contact is achieved.
*3
: If the head restraint interferes with your
child restraint system, and the head
restraint can be removed, remove the
head restraint.
Otherwise, put the head restraint in the
upper most position.
*4
: Use only a front-facing child restraint
system.
■ Detail information for CRS installation
Suitable for “universal” category
child restraint system fixed with
the seat belt.
Suitable for ISOFIX child restraint
system.
Includes a top tether anchorage
point.
Never use a rear-facing child
restraint system on the front pas-
senger seat.
Seating position
Seat position number
Seating position suitable for univer-
sal belted (Yes/No)
Yes
Forward-facing
only
No No
i-Size seating position (Yes/No) No No No
Seating position suitable for lateral
fixture (L1/L2/No)
No No No
Suitable rearward facing fixture
(R1/R2X/R2/R3/No)
No No No
To Next Page
