168
RCFOM(GE)1903
4-2. Driving procedures
The lever will return to its original posi-
tion immediately after operation.
1 Right turn
2 Lane change to the right (move the
lever partway and release it)
The right hand signals will flash 3 times.
3 Lane change to the left (move the
lever partway and release it)
The left hand signals will flash 3 times.
4 Left turn
■
If the turn signals do not stop flash-
ing after turning left or right, or if
you want to stop them flashing
Operate the lever in the opposite
direction to either position
2 or 3. If
you move the lever to either position
1
or
4, the selected turn signals will flash.
■
Turn signals can be operated when
The engine switch is in IGNITION ON
mode.
■
If the indicator flashes faster than usual
Check that a light bulb in the front or rear
turn signal lights has not burned out.
■
If the turn signals stop flashing before a
lane change has been performed
Operate the lever again.
■
Customization
Some functions can be customized.
(P.404)
Turn signal lever
Operating instructions