Lexus RC F User Manual

330
RCFOM(GE)1903
6-4. Do-it-yourself maintenance
for 1 minute and stays on to indicate a sys-
tem malfunction.
■ The tire pressure warning system
must be initialized in the following
circumstances:
 When rotating the tires.
 When the tire inflation pressure is
changed such as when changing
traveling speed.
 When changing the tire size.
When the tire pressure warning system
is initialized, the current tire inflation
pressure is set as the benchmark pres-
sure.
■ How to initialize the tire pressure
warning system
1 Park the vehicle in a safe place and
turn the engine switch off.
Initialization cannot be performed while
the vehicle is moving.
2 Adjust the tire inflation pressure to
the specified cold tire inflation pres-
sure level.
Make sure to adjust the tire pressure to the
specified cold tire inflation pressure level.
The tire pressure warning system will oper-
ate based on this pressure level.
3 Turn the engine switch to IGNI-
TION ON mode.
4 Press and hold the tire pressure
warning reset switch until the tire
pressure warning light blinks slowly
3 times.
5 Wait for a few minutes with the
engine switch in IGNITION ON
NOTICE
■ Repairing or replacing tires, wheels,
tire pressure warning valves, trans-
mitters and tire valve caps (vehicles
with the tire pressure warning sys-
tem)
● When removing or fitting the wheels,
tires or the tire pressure warning
valves and transmitters, contact your
Lexus dealer as the tire pressure warn-
ing valves and transmitters may be
damaged if not handled correctly.
● Make sure to install the tire valve caps.
If the tire valve caps are not installed,
water could enter the tire pressure
warning valves and the tire pressure
warning valves could be bound.
● When replacing tire valve caps, do not
use tire valve caps other than those
specified. The cap may become stuck.
■ To avoid damage to the tire pressure
warning valves and transmitters
(vehicles with the tire pressure warn-
ing system)
When a tire is repaired with liquid seal-
ants, the tire pressure warning valve and
transmitter may not operate properly. If a
liquid sealant is used, contact your Lexus
dealer or other qualified service shop as
soon as possible. After use of liquid seal-
ant, make sure to replace the tire pres-
sure warning valve and transmitter when
repairing or replacing the tire. (P.329)
Initializing the tire pressure
warning system (if equipped)
RC F_OM_General_OM24838E

Lexus RC F Specifications

General

Brand	Lexus
Model	RC F
Category	Automobile
Language	English