Lexus RC F User Manual

276
RCFOM(GE)1903
5-5. Using the other interior features
indicator light changes from slowly
flashing orange to rapidly flashing
green (rolling code) or continu-
ously lit green (fixed code), then
release the button.
 Programming an entry gate/Pro-
gramming the HomeLink
®
(garage
door type B)
3 Press and release the remote con-
trol transmitter button at 2 second
intervals, repeatedly, until the
HomeLink
®
indicator light
changes from slowly flashing
(orange) to rapidly flashing (green)
(rolling code) or continuously lit
(green) (fixed code).
4 Test the HomeLink
®
operation by
pressing the newly programmed
button and observing the indicator
light:
 Device with fixed code: If the indica-
tor light is solid/continuous, pro-
gramming has been completed and
your garage door or other device
should operate when the
HomeLink
®
button is pressed and
released.
 Device with rolling code: If the indi-
cator light flashes rapidly, your
garage door opener motor (or
other device) is equipped with a roll-
ing code. Complete the program-
ming process by firmly pressing and
holding the programmed
HomeLink
®
button for 2 seconds
and then release the button.
 If the garage door or other device
does not operate, proceed to “Pro-
gramming a rolling code system”.
5 Repeat the steps above to program
another device for any of the
remaining HomeLink
®
buttons.
■ Programming a rolling code sys-
tem
1 Locate the “Learn” or “Smart” but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the owner’s
manual supplied with the garage door
opener motor for details.
2 Press and release the “Learn” or
“Smart” button.
RC F_OM_General_OM24838E

Lexus RC F Specifications

General

Brand	Lexus
Model	RC F
Category	Automobile
Language	English