Finish
AUDIO
305
“−
+” switches: Use these switches to adjust the volume.
To increase the volume, push the “+”. To decrease the volume,
push the “–”. The volume continues to increase or decrease
while the switch is being pressed.
(a) When the radio mode is selected
“
” or “ ” switch: Use these switches for seek tuning or to
select a preset station.
To select a preset station, push this switch briefly. The
station you assigned to a switch on the audio system will be
selected.
To seek a station, push and hold this switch until you hear
a beep. The radio will begin seeking up or down for a station,
and will stop on reception.
(b) When the “TAPE” mode is selected
“
” or “ ” switch: Use these switches to fast forward or
rewind the tape or for automatic program selection.
To skip forward or reward for automatic program selection,
push this switch briefly. When automatically selecting a
program, you can skip up to 9 programs at a time. For
details, see page 276 or 296 for details.
To fast forward or rewind the tape, push this switch until you
hear a beep. To stop fast forwarding or rewinding, push the
same side on the switch briefly.
(c) When the “CD” mode is selected
“
” or “ ” switch: Use this switch to select a desired track.
Push this switch briefly, to select a desired track.
With a CD changer only —
“
” or “ ” switch: Use this switch to select a desired track
or CD.
To select a desired track, push this switch briefly.
To select a desired CD, push and hold this switch until the
desired number of the CD appears and you hear a beep.
Vehicles with rear seat entertainment system —
While the DVD player is in operation, the chapter or track can
be changed by pushing the “Ɯ” or “Ɲ” side of the switch.
CAUTION
Operate the switches with due care while you are
driving to avoid accidents.
To Next Page
