STARTING AND DRIVING
432
If “E3” appears on the display, a system malfunction has
been detected.
If this code appears, stop your vehicle in a safe place, turn the
ignition off, and then restart it to reset the system. If the setting
still cannot be made or the same code appears again, the
system might have malfunctioned. Although there is no
problem to continue driving, please contact your Lexus dealer.
Conventional (fixed speed) cruise control
mode
This mode allows you to cruise at a desired speed over
about 45 km/h (28 mph) with your foot off the accelerator
pedal.
Your cruising speed can be maintained up or down grades
within the limits of engine performance, although a slight speed
change may occur when driving up or down the grades. On
steeper hills, a greater speed change will occur so it is better
to drive without the cruise control.
CAUTION
In the conventional (fixed speed) cruise control
mode, the approach warning does not activate and
no alarm will sound even if you are too close to the
vehicle ahead, as neither the presence of the vehicle
ahead nor the vehicle−to−vehicle distance is
detected. Pay special attention to the distance
between your vehicle and the vehicle ahead. Always
confirm the setting in the display.
To Next Page
Loading...
