STARTING AND DRIVING
431
If “E1” appears on the display, the system cannot easily
measure the vehicle−to−vehicle distance because of a dirty
laser radar sensor glass while the dynamic laser cruise control
is on.
If this code appears, clean the sensor glass with a soft cloth
and try setting the preset speed again. If the dirt is removed
without cleaning, the system will automatically enter the ready
mode.
If the system does not enter the ready mode even after
cleaning or the code remains on the display, the system might
be malfunctioning. Although there is no problem to continue
driving, please contact your Lexus dealer.
CAUTION
Always keep the sensor glass clear and never allow it to
be covered with icicle or any substance, so it can detect
the vehicle in front.
If “E2” appears on the display, the system cannot easily
measure the vehicle−to−vehicle distance because of the
following conditions:
The wipers are operating at high or low speeds
Direct sunlight from the front
It is difficult to make a measurement because of bad
weather (such as rainy, foggy, or snowy weather)
Driving in “SNOW” mode
In the following cases, dynamic laser cruise control switches
to the ready mode:
The wipers are stopped or are switched to variable
intermittent operation.
No direct sunlight from the front
In the above conditions, push the lever up in the “+ RES”
direction and release it. Dynamic laser cruise control will be
restored. If the setting operation cannot be performed or if the
warning code still appears even after the weather clears, the
system might have malfunctioned. Although there is no
problem to continue driving, please contact your Lexus dealer.
To Next Page
Loading...
