STARTING AND DRIVING
443
CAUTION
Before you lower the vehicle’s height with the height
select switch, check under the vehicle to make sure
nothing that could damage the vehicle or no one who
could be injured is there and that the underbody of
the vehicle does not touch the ground.
Do not select the “HI” mode when you load cargo on
the roof luggage carrier. Otherwise it may result in a
loss of control or vehicle rollover due to failure to
operate this vehicle correctly.
NOTICE
If the vehicle height is changed frequently, the
compressor may overheat, causing the vehicle
height adjustment operation to stop.
After unloading, vehicle height rises slightly. Take
sufficient care where overhead space is restricted.
Do not select “LO” mode when on bumpy roads. If
the underbody of the vehicle touches the rugged
road surface, the vehicle may be damaged.
(d) Selecting the easy access mode
1
Easy access mode switch
2
Easy access mode indicator light
To select the easy access mode, push the easy access
mode switch. The easy access mode indicator light
comes on.
When the engine is stopped, the vehicle height changes
automatically to the easy access mode. The indicator light
blinks while the height changes. When the vehicle height
reaches the easy access mode, the indicator light turns off.
This mode is available when “N” or “LO” mode is selected.
When the engine is restarted in the easy access mode, the
easy access mode indicator light blinks. When the vehicle
begins to run or you push the height select switch to change the
mode, the indicator light will remain on.
To Next Page
Loading...
