Lexus RX450hL - Page 266

266
8-1. Phone operation (Hands-free system for cellular phones)
15 messages have already been stored.
1 Display the message screen:
 “MENU” button  “Phone” 
“Message”
2 Select a desired account name that
is displayed on the left side of
screen.
3 Select the desired message from
the list.
4 Select “Reply”.
5 Select “Quick Message”.
6 Select the desired message.
7 Select “Send”.
“Cancel”: Select to cancel sending the
message.
 While the message is being sent, a
sending message screen is dis-
played.
8 Check that a confirmation screen is
displayed when the operation is
complete.
 If an error message is displayed, fol-
low the guidance on the screen to
try again.
■ Editing quick reply messages
This operation cannot be performed
while driving.
1 Select “Reply”.
2 Select “Quick Message”.
3 Select corresponding to the
desired message to edit.
4 Select “OK” when editing is com-
pleted.
● To reset the edited quick reply messages,
select “Default”.
● Quick message 1 (“I am driving and will
arrive in approximately [##] minutes.”)
*
:
This message cannot be edited and will
automatically fill in [##] with the naviga-
tion calculated estimated time of arrival
on the confirm message screen.
If there are waypoints set, [##] to the next
waypoint will be shown.
If there is no route currently set in the
navigation system, quick message 1 can-
not be selected.
● Depending on the type of Bluetooth
®
phone, reply function is not available.
*
: With navigation function
Calls can be made to an
e-mail/SMS/MMS message sender’s
phone number.
This operation can be performed while
driving.
■ Calling from e-mail/SMS/MMS
message display
1 Display the message screen:
 “MENU” button  “Phone”
 “Message”
2 Select a desired account name that
is displayed on the left side of
screen.
3 Select the desired message from
the list.
4 Select , or press the switch
on the steering wheel.
 If there are 2 or more phone num-
Replying to a message (quick
reply)
Calling the message sender