EasyManuals Logo

LEYBOLD ECODRY plus 25 User Manual

LEYBOLD ECODRY plus 25
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
CAUTION: GAUGE MALFUNCTION
Risk of damage to equipment. Do not make connections to the gauge identication
pin (pin 4). Failure to do so can cause the gauge to malfunction.
CAUTION: GAUGE CONNECTION
Risk of damage to equipment. Do not connect a gauge input and analogue input
signal at the same time. This will result in the wrong speed demand.
Figure 4.
Gauge connection
1. Electrical supply positive 2. Electrical supply ground
3. Pressure measurement input signal 4. Not connected
5. Signal ground 6. Not connected
7. Not connected 8. Not connected
1. Electrical supply positive 2. Electrical supply ground
3. Pressure measurement input signal 4. Not connected
5. Signal ground 6. Not connected
7. Not connected 8. Not connected
2.6 Auto-run
The autorun setting congures the pump to start automatically when the
power is switched on, without any customer intervention.
You can congure the autorun through serial communications, or with the
start or stop button. Push and hold the start or stop button for more than
eight seconds to enable or disable the auto-run setting. The auto-run LED
displays the auto-run setting.
The pump can be stopped by either manual, parallel or serial control modes
when in autorun mode.
Note:
Refer to Operation safety on page 25 for guidelines on how to congure
different operational modes and any associated warnings to consider.
2.7 Pump controller conguration
The integral pump controller monitors the power and temperature of the
pump. The pump controller protects the user and the pump when the pump
is operated under sustained high load or in fault conditions.
The pump controller is connected to the interface control panel and the
pump can be operated:
manually, with the buttons on the user interface control panel. Refer to
Figure: Interface control panel.
remotely, with serial or parallel communications through the SUB-D 9-
pin connector located on the rear of the pump. Refer to Connection for
remote control and monitoring on page 23.
13
300902516_002 - 10/2020 - © Leybold
General description

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LEYBOLD ECODRY plus 25 and is the answer not in the manual?

LEYBOLD ECODRY plus 25 Specifications

General IconGeneral
BrandLEYBOLD
ModelECODRY plus 25
CategoryWater Pump
LanguageEnglish

Related product manuals