10 Storage
WARNING: HAZARDOUS SUBSTANCES
Risk of injury or damage to equipment. Do not drain oil from the pump. Install the
blanking plates to seal the vacuum inlet and outlet ports. The pump must be stored in
a horizontal conguration to prevent possible oil leakage.
WARNING: INHALATION HAZARD
Risk of asphyxiation. Do not burn the uoroelastomer seals, tip seal material or
O‑rings.
To store the pump:
1. Shut down the pump. Refer to Shut down the pump on page 31.
2. Disconnect the pump from the electrical supply.
3. Place and secure protective covers over the inlet and outlet ports.
4. Store the pump in a clean and dry condition until required for use.
5. When necessary, prepare and install the pump. Refer to Installation on
page 18.
300902516_002 - 10/2020 - © Leybold
54
Storage
To Next Page
Loading...
Need help?
General
