LG CK99 - MIX; Tempo; Auto Sync

Operating
25
Operating
3
MIX
You can mix audio sounds.
1. Press MIX on the unit.
‘MIXER ON’ is displayed. Select a desired function
for side 1 and play it. Mix is available in all
functions except USB 2.
2. During playback, insert a USB device in USB 2
port and play it. Side 2 is fixed as USB 2 function.
3. Move the cross fader to adjust the sound volume
of mixed sound.
Move it to the left to lower the volume of
side 2 and move it to the right to lower the
volume of side 1.
y In MIXER ON mode,
- You can adjust the Tempo for USB function
1 or 2.
- If you press C/V, Z or N on the unit,
it works only for each side.
- If you press C/V, Z or N on the
remote control, it works for both side 1
and side 2.
- For operating, it is recommended to use
C/V, Z or N on the unit instead of
remote controls.
- Numerical, DELETE buttons do not work.
- You can use H/P MODE. (Page 40)
y If you turn off the unit in the middle of mixing
process, MIX mode turns to OFF.
,
Note
TEMPO
You can adjust the Tempo for USB function from 50
(MIN) to 150 (MAX).
Rotate TEMPO A on the unit to adjust the tempo for
USB 1. Rotate TEMPO B on the unit to adjust the
tempo for USB 2.
y The tempo is set as 100 if you turn the unit
on/off or fully stop.
y The tempo is kept when you pause and
resume play.
,
Note
AUTO SYNC
When using Mixing, you can synchronize the tempo
of audio les being played in USB 1 and USB 2 by
pressing AUTO SYNC on the unit.
To stop it, press AUTO SYNC on the unit twice.
y The tempo of music being played in USB 1 is
synchronized to that in USB 2.
y TEMPO A doesn’t work when AUTO SYNC
is on.
y If USB 2 fully stops or function is changed,
AUTO SYNC function is cancelled.
y In case of below, AUTO SYNC error may occur
depending on the sound source.
- The silent section in the beginning of the
track.
- Intro or bridge section in which few
musical instruments appear.
- In cases where playback speed or tempo
of the song changes.
- In case that the data for BPM is provided
in real time, not the beginning of the song.
y If the song is being played too fast or slow,
press and hold AUTO SYNC.
‘AUTO SYNC RE-ANALYZING’ is displayed.
y AUTO SYNC is available only when USB 1 is
selected for side 1 and USB 2 is selected for
side 2 in MIXER ON mode and both are being
played.
,
Note