LGMG MT86 - Page 33

MT86 Operation and Maintenance Manual
27
Items
Parameters
Seat width
510mm
Seat height
855mm
Height
adjustment
0～40mm
Front/rear
adjustment
travel
180mm
Backrest
angle
adjustment
0-70° (backward in
relationship to plumb
line)
0-40° (forward in
relationship to plumb
line)
Adjustment
range of
driver’s
weight
50～110kg
will be off.
4) Interior lighting
After the battery box switch is turned on and the
interior ceiling lamp switch is pushed to one side (both
the right and left are ok), the interior lighting lamp will be
on and off (as shown in left figure).
3.2.8 Seat
The seat is designed for construction machinery and mining
dump truck. The seat top and shock absorber are designed
under full consideration of driver’s safety and comfort based
on kinematics.
The seat backrest designed as luxurious high backrest applies
the latest principle of human environmental science and
human kinetics to effectively support the driver’s shoulder,
thus relieving the fatigue.
Seat adjustment method:
1) Backrest elevation adjustment: move handle upward
forcibly, turn the backrest to the
required angle and release the handle to lock the backrest.
Range：0～60mm。
2) Horizontal adjustment: pull handle 2 upward to move the
seat forward and backward to the required position, and
release the handle to lock.
Range：Forward 80mm，Backward 80mm。