3) Front height adjustment: move handle upward gently to
exert to or relieve from the front end of cushion upwards or
downwards an appropriate force to lower (lift) it to the
required position, and release the handle to lock.
Range：0～60mm。
4) Load weight adjustment: rotate front handle forcibly and
adjust it appropriately according to the driver's weight. The
rotation direction corresponding to weight increase and
decrease is marked on the handle.
Range：40～130 kg。
5）Backrest elevation adjustment: move handle upward
forcibly, turn the backrest to the required angle and release
the handle to lock the backrest.
Range：40°～180°
△
! CAUTION: While adjusting the seat
backrest, do not lean back too much in case of
hidden danger caused by triggering rear
window.
3.2.9 Transmission gearshift lever
The gearshift lever is installed on the engine hooding. In
this way, the disturbance of cab vibration and the
possibility of disengagement will be eliminated, and the
cab tilting will not be affected.
3.2.10 Hand brake valve (spring parking brake)
The hand brake valve is located at the right side of
seat (The shown brake valve handle is located at
“BRAKE” position). Provided the parking brake signal
lamp is off, the air pressure will exceed 0.55 Mpa, the
To Next Page
Loading...
