NEUTRAL position. Turn the key switch to START to
start the engine.
△
! CAUTION: If the engine cannot get started
successfully for the first time, set the key switch to
ACC, and start the engine again. The time for
each starting shall be no more than 15 s, and the
interval between two successive start-ups shall be
no less than 60 s. However, if it is not possible to
start up for three successive times, stop it until
any fault has been identified and cleared. After
the engine has been started, make it idle for a few
minutes, and then increase the speed to
1,000-1,200r/min, and apply partial load.
Full-load operation is allowed only when the
outlet temperature is higher than 60℃, and the
engine oil temperature is higher than 50 ℃. The
load and speed shall be increased gradually to
avoid sudden load adding or shedding.
3) Oil pressure after start-up
After the engine gets started, observe the pressure
value indicated on the oil gauge. Meanwhile, the oil
pressure indicator lamp shall be off.
△
! CAUTION: Never run a cold engine at a
high temperature! If the oil gauge gives no
To Next Page
Loading...
