Libre LS9 - WPS Trigger from Command Line; WPS Trigger from LUCI

To Next Page

To Previous Page

LS9 User Guide

Libre Wireless Technologies User Guide : LS9 / LS9AD, Ver. 5.3 Page 35 of 75

Libre Confidential

4.3. WPS Trigger from Command Line

To setup a wireless network using WPS proceed as below

Step 1. On system boot, enter the command #wpa_cli wps_pbc in device

terminal

Step 2. Trigger (Press Once) Setup button in the Access Point.

Device connects to the Network of the Access Point.

Step 3. To know the newly acquired IP execute command #netcfg in the device

terminal

End--

4.4. WPS Trigger from LUCI

You can setup a wireless network for the LS-Enabled speaker, using the LUCI Message-

Box #141. Message-Box #141 is used by Host to trigger WPS mode.

For more information see section 6 in LUCI Technical Note,

LibreWirelessTechNote - LS_Light_Weight_Universal_Control_Interface.