Lifeloc FC10 - Lifeloc FC10 User Settings Configuration; Setting the Default Test Order; Setting the Trigger Mode

13
Lifeloc FC10
www.Lifeloc.com | 303-431-9500
Setting Trigger Mode
From the “SETTINGS” display, press the Execute button.
Press the Function button until the display reads “TRIGGER MODE.”
Press the Execute button to select between “END OF BREATH” and “PRECISE VOLUME.”
Press the Function button to save the setting. Momentarily press Power to return to the
testing mode.
(User settings fl ow chart is shown on p. 26)
User Settings
Setting the Default Test Order
Press the Function button until the display reads “SETTINGS”.
Press the Execute button. Display reads “TIME”.
Press the Function button until the display reads “DISPLAY SETTINGS”.
Press the Execute button. Display reads “LCD CONTRAST”.
Press the Function button. Display reads “TEST ORDER”.
Press the Execute button to toggle between Test Order 1, 2, and 3 above.
Press the Function button to save the changes.
Momentarily press Power to return to the testing mode.
Please note: By selecting Test Order 3 you will disable passive testing.
(User settings fl ow chart is shown on p. 26)
Test Order 1 (Default) Test Order 2 Test Order 3
Auto Test Passive Test Auto Test
Manual Test Auto Test Manual Test
Passive Test Manual Test