USER MANUAL – EASYLIFT V3 PLUS – AU VERSION 09.02
Liftup A/S Hagensvej 21 | DK-9530 Støvring | Danmark | T: +45 96 86 30 20 | M: support@liftup.dk | www.liftup.dk | CVR: DK-1015 3964
6.5 Overload of the lift
In order to avoid damage to equipment due to overloading (max. 750 lbs/340 kg (EasyLift
800/900 V3 PLUS) or 880 lbs/400 kg (EasyLift 1100 V3 PLUS) evenly distributed), the lift is fitted
with overload protection which stops the lift and issues an audible alarm if overload occurs. In
the event of overload, run the lift downward to exit.
6.6 Personal safety
The lift is fitted with various safety features which ensure that the user or other people are not
injured when using the lift.
WARNING! Although the lift comes fitted with various safety features, never use it if
persons or animals are close by, as there may otherwise be a risk of crushing.
Never allow children to play with the lift.
6.7 Anti-crushing
Beneath the entire lift a number of push plates (anti-crushing) are fitted which are activated if
an object is going to be crushed below. When this feature is activated, the lift stops and then
runs approx. 2 cm upwards, while at the same time an audible alarm is issued (see section 10.8).
If the anti-crushing feature is activated, release the operating button. Remove any objects under
the lift and then again run it to floor level. (If needed, move the lift up a small distance so you
can easily remove objects from under it).
IMPORTANT! Keep in mind that when the lift is used outdoors, leaves, branches and
snow can affect the anti-crushing safety feature, and so you should check regularly
that the lift will not be obstructed when moving downward.
For outdoor installations we recommend returning the lift to ground level after use,
in order to prevent unwanted objects finding their way under the lift
Anti-crushing
protection zone
To Next Page
Loading...
